Replacing your window is not a huge task that requires a bunch of individuals. Instead, it can be done by you, once you can make sure to follow essential guidelines and have the right tools. Soon after accomplishing both these aspects, you will be able to replace that window and understand the simplicity of the task. As it also involves minimum steps, the process is not time-consuming. So to help you out, here are all the essential tips and tools needed for replacing your window.
Steps
- Remove the Old Window – the very first step of the process requires you to remove the window that needs to be replaced. If you also require a new windowpane, then the entire structure needs to go.
- Adjustments – soon after removing, the next step is to ensure that the headers and studs are well adjusted. Apart from that, you also need to look into the dimension and acknowledge whether or not it fits the new window adding new boards to the frame and removing a part of the sliding on the exterior are tasks usually seen during this stage.
- Installation – once you’re done making all the required arrangements, you can proceed to install the new window. Calling out for an extra pair of hands sounds like a good idea if you’re not able to keep things in place. But the application is quite simple, and if the measurement is accurate, then you have nothing to worry about. Installing it from the exterior by pushing the window up until it is flush to the frame is how it is usually done.
- Wrapping – after putting the window and nailing it into the place, one needs to add another layer of window wrap. This process covers the surface and will not leave any gaps in the middle. By doing so, you will be keeping moisture out, as it remains straight for a long time.
- Insulate – the task of insulating the window is often ignored, and people fail to do so. But to be on the safer side, it is always good to insulate the window by putting an expanding=foam of sealant. This needs to go in the gap between the casing and the window.
- Scrapping – once the foam is dry, you need to scrap it away by using a knife and cut away the excess part.
Tools
- Waterproof Shims
- Safety glasses
- Hammer
- Power Drill
- Screwdriver
- Putty and utility knife
- Measuring tape
- Level
These tools tend to act as necessities during the process. So go out, grab hold of them and then proceed ahead to replace your window.
